SECTION 11—WHEELS AND CASTERS
At’m 48 Part No. 1125035
Installing
1. Align drive wheel axle with the wheelchair frame.
2. Push and hold the quick-release button on the drive wheel and push the drive wheel
into the wheelchair frame.
3. Engage the motor. Refer to Engaging/Disengaging the Motors on page 42.
4. Repeat STEPS 1-3 for the other drive wheel.
WARNING
Pull the drive wheel to ensure that the drive wheel is locked in place before operat-
ing the wheelchair - otherwise serious injury or damage may occur.
FIGURE 11.3 Removing/Installing the Drive Wheels
Replacing the Flat Free Tires on the Wheel Rim
WARNING
DO NOT attempt to replace flat free tires. This procedure MUST be performed by
a qualified technician.
NOTE: During initial use of the wheelchair, the user may experience flat spots on the wheels. Flat
spots will vanish with continued use of the wheelchair.
Motor Engagement Handle in
the Disengaged Position
Drive Wheel
Drive Wheel
Drive Wheel Axle
Wheelchair Frame
Top view
Side view
Quick-Release
Button
To Next Page
