SECTION 12—TRANSPORTING THE WHEELCHAIR
Part No. 1125035 49 At’m
SECTION 12—TRANSPORTING THE
WHEELCHAIR
WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
ALWAYS transport the battery pack/box in an upright and secure manner. To
prevent damage, do not transport the battery pack/box with other objects that
could suddenly shift during transportation, unless they are secured or in a different
vehicle area. DO NOT transport battery pack/box with gas cans or similar
containers in the same vehicle area.
The weight of the wheelchair without the user and batteries is approximately 74 lbs.
Use proper lifting techniques (lift with your legs) to avoid injury. Extreme caution is
advised when it is necessary to move an unoccupied power wheelchair. Invacare
recommends using two assistants and making thorough preparations. Make sure to
use only secure, non-detachable parts for hand-hold supports.
NOTE: For this procedure, refer to FIGURE 12.1.
1. Remove the occupant from the wheelchair.
2. Remove the battery pack or battery box. Refer to Removing/Installing the Battery Pack
on page 36.
3. Remove the seat. Refer to Removing/Installing the Seat on page 29.
4. Remove any accessories on the wheelchair.
5. Bend your knees and keep your back straight.
6. Using non-removable (nondetachable) parts, transfer the seat, battery pack or battery
box, wheelchair base and any accessories to the desired location.
7. Reinstall any accessories that were removed in STEP 3.
8. Reinstall the seat. Refer to Removing/Installing the Seat
on page 29.
9. Reinstall the battery pack or battery box. Refer to Removing/Installing the Battery
Pack on page 36.
To Next Page
Loading...
