28
6.1.1 Status display
NOTE:
The ON/OFF diode is used as a fault display (status display). Chapter "Error Codes and
Diagnostic Codes" on page 35 contains an explanation of the error codes.
6.1.2 Battery charge display
• All diodes illuminate: maximum driving range
• Only red and yellow diodes illuminate: reduced driving range. Recharge the batteries at the
end of your journey.
• Only red LEDs illuminate/blink, electronics beeps 3x: battery reserve = severely
restricted driving range. Recharge batteries immediately!
NOTE:
Overdischarge protection: after a certain drive time on reserve battery power the electronics
system switches the drive off automatically and brings the Scooter to a standstill. If you do not
drive your Scooter for a while the batteries will "recuperate" and allow a further, but short,
journey. However, after a very brief journey the red diodes will illuminate again and the electronic
system will beep three times. This procedure leads to battery damage and should be avoided if
possible!
To Next Page
Loading...
