33
6.4 Diagnosis and fault repair
The electronic system offers diagnostic information to support the technician during the recognition
and rectification of faults on the Scooter. If there is a fault, the status display blinks several times,
pauses, then blinks again. The type of fault is displayed by the number of blinks in each group,
which are also known as the "blink code".
The electronic system reacts differently depending on the seriousness of the fault and its effect on
user safety. It can, for example:
• simply show the blink code as a warning and allow both driving and normal operation to
continue;
• display the blink code, stop the Scooter and prevent further travel until the electronic
system has been switched off and switched on again;
• display the blink code, stop the Scooter and not permit further travel until the fault has been
rectified.
You can find detailed descriptions of individual blink codes, including possible causes and fault
repair, in the section entitled "Error Codes and Diagnostic Codes" on page 35.
To Next Page
Loading...
Need help?
General