29
6.2 Driving the Scooter
• Switch the power supply on (keyswitch) The operating console display illuminates. The Scooter
is ready to drive.
NOTE:
If the Scooter is not ready to drive after switching on, check the status display (see Chapter
"Status display" on page 28 and Chapter "Diagnosis and fault repair" on page 33.
• Set the required speed with the speed controller.
• Pull the right-hand drive lever carefully to travel forwards.
• Pull the left-hand drive lever carefully to travel in reverse.
NOTE:
The control system is programmed with standard values in the works. Your Invacare®dealer can
carry out programming tailored to fit your requirements.
CAUTION: any changes to the drive program can affect the driving characteristics and the
tipping stability of the vehicle!
• Changes to the drive program may only be carried out by trained Invacare® specialist
dealers!
• Invacare® supplies all mobility products with a standard drive program ex-works. Invacare®
can only give a warranty for safe vehicle driving behaviour - especially the tipping stability -
for this standard drive program!
To Next Page
Loading...
