EasyManua.ls Logo

Invacare Comet Series PRO - User Manual

Invacare Comet Series PRO
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
InvacareĀ® Comet Series
Comet
PRO
, Comet
ALPINE+
, Comet
ULTRA
en Scooter
UserManual
ThismanualMUSTbegiventotheuseroftheproduct.
BEFOREusingthisproduct,readthismanualandsaveforfuturereference.

Table of Contents

Questions and Answers

  • R
    Rhonda HaynesJul 27, 2025
    What to do if Invacare Comet PRO battery voltage is too low?
    • E
      Earl ValdezJul 27, 2025
      If the battery voltage of your Invacare Scooter is too low, you should charge the batteries. In an emergency, switching the scooter off for a few minutes might allow a short journey, but this can excessively discharge the batteries.
  • M
    maria82Aug 1, 2025
    What to do if Invacare Scooter has brake failure?
    • M
      Manuel FarrellAug 1, 2025
      If you are experiencing brake failure with your Invacare Scooter, first ensure that the disengaging lever is in the engaged position. Then, check the magnetic brake and cabling for open or short-circuited circuitry.
  • K
    Kelly Ramirez MDAug 6, 2025
    What to do if Invacare Comet PRO Scooter battery voltage is too high?
    • G
      gmillerAug 6, 2025
      If the battery voltage of your Invacare Scooter is too high, disconnect the battery charger from the scooter if it is connected. If this doesn't help, switch the scooter off and on again.
  • A
    adam96Aug 11, 2025
    What to do if Invacare Comet PRO power time exceeded?
    • Z
      Zachary WilliamsonAug 11, 2025
      If the power time has been exceeded on your Invacare Scooter, switch the scooter off, wait a few minutes, and then switch it on again. Also, check the wiring harness for a short-circuit and inspect the motor.
  • D
    Dawn RamirezAug 16, 2025
    What to do if Invacare Scooter has no neutral position?
    • L
      leedonAug 16, 2025
      If your Invacare Scooter has no neutral position when switching it on, put the drive lever in neutral, turn the power off, and then turn it on again.
  • I
    Ian RobinsonAug 21, 2025
    What to do if Invacare Comet PRO has push/freewheel mode error?
    • C
      Cynthia KellyAug 21, 2025
      If there is a push/freewheel mode error on your Invacare Scooter, switch the electronics system off and on again.

Summary

Safety Guidelines

General Safety Notes

Essential safety precautions for operating the mobility device.

Electrical System Safety

Safety information regarding the mobility device's electrical system.

Driving and Freewheel Mode Safety

Safety information for driving and using freewheel mode.

Care and Maintenance Safety

Safety information regarding the care and maintenance of the device.

Usage and Operation

Taking Obstacles

Guidance on safely navigating and overcoming obstacles.

Driving the Scooter

Detailed instructions on how to drive the mobility device.

Batteries and Maintenance

Battery Charging Information

General information and instructions for charging the batteries.

Transport and Troubleshooting

Diagnosis and Fault Repair

Steps for identifying and rectifying common device faults.

Error Codes

Detailed list of error codes and their meanings.

Technical Data and Service

Invacare Comet Series PRO Specifications

General IconGeneral
Ground Clearance3 inches (7.6 cm)
Seat Width18 inches (46 cm)
Seat Depth16 inches (41 cm)
Motor24V
Battery2 x 12V
Battery Type2 x 12V
ChargerOff-board
Drive SystemRear-wheel drive
Braking SystemElectromagnetic
Tire TypePneumatic

Related product manuals