What to do if Invacare Scooter has fault in speed potentiometer?
If there's a fault in the speed potentiometer of your Invacare scooter, check the cabling for open or short-circuited circuitry. Also, the potentiometer may not be correctly adjusted and might need replacement.
What to do if my Invacare Leo batteries are not charging?
If your Invacare Scooter batteries are not charging, try these steps: Switch to another wall outlet to ensure there is current. Check all connections and secure any that are loose. If the issue persists, the charger may need to be replaced, or internal repairs may be required.
What to do if the battery indicator on my Invacare Leo shows low charge too soon after recharging?
If the battery indicator shows a low charge too soon after recharging, it could be due to a faulty charger. Weak batteries can also cause this issue, so consider replacing them.
What to do if my Invacare Leo will not drive?
If your Invacare Scooter won't drive, several factors could be at play. First, the brake release lever might be disengaged, so ensure it is properly engaged. Next, the batteries may need charging. Also, confirm that the key is fully inserted into the key switch and that the charger is unplugged from the scooter. A blown fuse in the battery box or loose battery connections could also be the cause. Check all connections to ensure they are secure. If a service indicator light is flashing on the control panel, count the flashes and refer to the Service Indicator Error Codes.
What to do if Invacare Scooter motor voltage error?
If you are experiencing a motor voltage error with your Invacare scooter, check the cabling for open or short-circuited circuitry.
What to do if Invacare Scooter has push/freewheel mode error?
If your Invacare scooter shows a push/freewheel mode error, switch the electronics system off and on again.
How to fix issue 9 with Invacare Leo Scooter?
Check all connections & wiring.
What to do if problem 10 occurs with Invacare Leo?
Turn the scooter off and then on again.
Why do the batteries on my Invacare Leo Scooter draw excessive current when charging?
The batteries may draw excessive current when charging due to battery failure. If this occurs, replace the batteries.
How to fix Invacare Scooter that runs too slowly?
If your Invacare Scooter is running too slowly, the operating console might be defective, requiring replacement. Another possibility is that the batteries are defective and also need replacement.
General| Maximum Speed | 8 km/h |
|---|---|
| Weight Capacity | 136 kg |
| Ground Clearance | 7 cm |
| Battery | 2 x 12V |
| Seat Width | 47 cm |
| Seat Depth | 41 cm (16.1 inches) |
| Maximum Safe Slope | 10 degrees |
| Turning Radius | 43.3 inches (110 cm) |
Details safety symbols used in the manual, including general risks, explosion, burn hazards, and crushing risks.
Explains symbols found on the product, focusing on environmental responsibility and recycling.
Classifies the vehicle and outlines its intended use for persons with impaired walking ability, tested to EN 12184.
Outlines the terms and conditions of the warranty specific to individual countries.
Estimates the product's life expectancy based on usage, maintenance, and technical advancements.
Covers essential safety precautions for operating the scooter, including risks of injury from misuse, impairment, and accidental motion.
Highlights the importance of regular inspections and maintenance for safety and guarantee validity.
Warns about potential malfunctions due to electromagnetic interference and provides precautions.
Provides safety instructions for driving, especially concerning gradients, obstacles, and tipping hazards.
Guides users on familiarizing themselves with the scooter's operation and controls before the first trip.
Explains how to safely climb and descend kerbs and obstacles, with warnings about tipping.
Provides safety advice for driving up and down slopes, including speed limits and avoiding slippery surfaces.
Instructs on how to park the scooter safely, including switching off the power supply.
Details the procedure for disengaging the scooter's motors for manual pushing, with safety warnings.
Identifies and describes the components and controls on the operating console.
Explains how to safely operate the scooter using the drive levers and speed controller.
Describes how to customize acoustic signals for various functions using specific key combinations.
Details the electronic system's diagnostic capabilities and fault reporting through blink codes.
Provides a comprehensive list of error codes, their consequences, and troubleshooting comments.
Instructions on how to adjust the seat forwards or backwards using the disengaging lever.
Details the process of adjusting the width of the armrests using handwheels under the seat.
Explains how to disengage, rotate, or remove the seat for easier access or maintenance.
Provides steps for adjusting the seat height using specific tools and components.
Information on postural belts, including types, fitting, and correct adjustment for user support.
Details the optional rollator bracket, approved rollators, weight limits, and tipping risks.
Describes the overload-protection system for the vehicle's electronics and potential overheating scenarios.
Provides essential information about the 12V batteries, their maintenance, charging, and handling.
Details the charger's features, characteristics, instructions for use, LED display, and troubleshooting steps.
Instructions for cleaning the scooter, emphasizing the use of a damp cloth and gentle detergent.
Lists routine inspection jobs for the user, including checks for tires, wheels, and electrical systems.
Provides guidance on repairing flat tyres, including safety warnings and procedures for tyre removal and fitting.
Step-by-step instructions for removing the seat for easier transport.
Guides on how to remove the battery and drive unit for dismantling the scooter.
Specifies the permissible temperature ranges for operation and storage according to ISO standards.
Details the motors, batteries, and main fuse specifications for the electrical system.
Lists the specifications for the charger, including output current, voltage, and input voltage.
Provides key driving performance data such as speed, braking distance, slope capability, and turning diameter.
Lists the physical dimensions of the scooter, including overall size, seat dimensions, and weight.
Provides contact information for the primary manufacturer, Chien Ti Enterprise Co. Ltd.
Identifies the European representative, Emergo Europe, with its address.
Lists distribution contacts for various European countries including France, Italy, Spain, Portugal, UK, and Ireland.
Provides contact details for distribution in Sweden, Denmark, Netherlands, Germany, and Eastern Europe.
To Next Page
