Invacare Leo - Removing;Fitting Tyres (4-Wheel Version and Rear Wheels of 3-Wheel Version)

71
11.1.1 Removing/fitting tyres (4-wheel version and rear wheels of 3-wheel version)
Required items:
• 17 mm spanner
• Rubber mallet
• Screwdriver
• 17 mm safety nut
Removing the tyres
• Jack the vehicle up and place a block of wood underneath it
to prop it up.
• Remove the plastic cap.
• Remove the wheel safety nut (1) using the 17 mm spanner.
• Remove the wheel by giving it a few light taps on the back
with the rubber mallet to release it from the axle.
Fitting the tyres
• Fit the tyres following the sequence described above in
reverse order.
• Use a new wheel safety nut.
Problems removing the wheel?
You may need to use a special tool. Please contact your authorised Invacare® dealer for
assistance.