Why is the battery voltage too high on my Invacare Horizon?
If the battery voltage of your Invacare Scooter is too high, and a charger is plugged in, unplug it or turn the Charge/Run switch to Run. Scooters powered by RHINO charge the batteries when travelling down slopes or decelerating, and excessive charging in this manner can cause this fault. Turn the scooter power off then on again. If necessary, reduce speed when descending the slope.
What to do if the battery voltage is too low on my Invacare Horizon Scooter?
If the battery voltage of your Invacare Scooter is too low, recharge the batteries. If the scooter is left off for a few minutes, battery charge might recover enough to allow driving for a short time because the battery charge is empty.
What to do if Invacare Horizon Scooter will not move when the key is turned on?
If your Invacare Scooter will not move when the key is turned on, check the power reserve indicator on the control panel. All the LED lights should be on. Check the Self-Diagnostic Warning Light. It should be steady. If it is flashing, see chart on page 18 for problem identification. Check all electrical connections to be sure they are tight. If none of these correct the problem, contact your authorized dealer.
What to do if the current limit time-out on my Invacare Scooter?
If your Invacare Scooter's current limit has timed out, turn the scooter power off, leave it for a few minutes, and then turn the power back on again. The controller may have detected a shorted motor, so check the loom for shorts and check the motor. Contact your service agent.
What to do if there is a brake fault on my Invacare Scooter?
If your Invacare Scooter has a brake fault, check that the park-brake release lever is in the engaged position. Check that the motor/ park-brake connector is plugged in firmly. Check the park brake and wiring for open or short circuits. If necessary, unplug the motor/park-brake connector and check that all four pins are in the correct position. If this flash code does not appear until the throttle has been moved out of neutral, check for a short in the park-brake circuit. If this flash code appears at power-up, check for an open circuit in the park-brake circuit. Contact your service agent because the park-brake coil or wiring might be faulty.
What to do if my Invacare Scooter is out of neutral at power-up?
If your Invacare Scooter is out of neutral at power-up, return the thumb lever to neutral, turn the power off, and back on again. The throttle may need to be re-calibrated, so check throttle wiring because the thumb lever might not be in neutral position when turning key switch on.
Clean body cover with a damp or soapy cloth. Avoid running water for electrical parts.
Use a damp cloth for upholstery. Sun damage is normal wear and tear, not covered by warranty.
General| Charger Type | Off-board |
|---|---|
| Ground Clearance | 3.5 inches (8.9 cm) |
| Range | Up to 25 miles (40 km) |
| Range per Charge | Up to 25 miles (40 km) |
| Overall Length | 48 inches (122 cm) |
To Next Page