What should I do if my Invacare Remote Control displays 'Motor 21 error'?
If your Invacare Remote Control displays a 'Motor 21 error', start by checking the cables and connectors to ensure they are properly connected. If the issue persists, contact your provider.
What to do if the Invacare Remote Control status display is OFF?
If the status display on your Invacare Remote Control is OFF, first check whether the drive electronics system is switched on. Next, verify that all cables are correctly connected. Finally, ensure that the batteries are not discharged.
What to do if I see a 'Module error (other than remote module)' on my Invacare Remote Control?
If your Invacare Remote Control displays a 'Module error (other than remote module)', check the cables and connectors, and verify the modules. Recharge the batteries. Also, if the chair was stalled, reverse away or remove the obstacle. If the issue continues, contact your provider.
General| Brand | Invacare |
|---|---|
| Model | LiNX DLX-REM110 |
| Category | Remote Control |
| Language | English |
Provides essential safety instructions and warnings for operating the device.
Covers principles of power wiring and cable securing for safe operation.
Explains how to power the remote up and down and basic operation.
Details how the joystick controls direction and speed of the wheelchair.
Explains how to use the speed dial to adjust maximum speed.
Describes how to perform an emergency stop using the ON/OFF button.
Introduces the operation of powered seating functions.
Details how to switch between different drive functions.
Provides instructions and warnings for charging the batteries.
Guides on how to diagnose faults using the status display.
Lists fault codes indicated by status indicator flashes and their meanings.
Explains the "Out Of Neutral" safety feature.
Describes the drive inhibit mode and its indications.
To Next Page
