What to do if my Invacare LiNX DLX-REM110 displays a module fault (other than remote module)?
If your Invacare Remote Control displays a module fault (other than the remote module itself), you should: * Check the cables and connectors. * Check the modules. * Recharge the batteries. * If the chair was stalled, reverse away or remove the obstacle.
What to do if the Invacare Remote Control shows a 'Right magnetic brake error'?
If your Invacare Remote Control indicates a 'Right magnetic brake error', start by checking the cables and connectors. Also, check that the right magnetic brake is engaged. If problems persist, contact your provider.
What to do if the Invacare Remote Control shows a 'Left magnetic brake error'?
If your Invacare Remote Control indicates a 'Left magnetic brake error', start by checking the cables and connectors. Then, check that the left magnetic brake is engaged. If problems persist, contact your provider.
What to do if I see a 'Module error (other than remote module)' on my Invacare Remote Control?
If your Invacare Remote Control displays a 'Module error (other than remote module)', check the cables and connectors, and verify the modules. Recharge the batteries. Also, if the chair was stalled, reverse away or remove the obstacle. If the issue continues, contact your provider.
What to do if the Invacare Remote Control status display is OFF?
If the status display on your Invacare Remote Control is OFF, first check whether the drive electronics system is switched on. Next, verify that all cables are correctly connected. Finally, ensure that the batteries are not discharged.
What should I do if my Invacare Remote Control displays 'Motor 21 error'?
If your Invacare Remote Control displays a 'Motor 21 error', start by checking the cables and connectors to ensure they are properly connected. If the issue persists, contact your provider.
What should I do if my Invacare Remote Control displays 'Motor 11 error'?
If your Invacare Remote Control displays a 'Motor 11 error', start by checking the cables and connectors to ensure they are properly connected. If the issue persists, contact your provider.
What to do if the Invacare Remote Control shows a network or configuration error?
If you encounter a network or configuration error with your Invacare Remote Control, first check the cables and connectors to ensure they are properly connected. Then, try recharging the batteries and inspect the charger. If problems persist, it may be necessary to contact your provider.
What to do if my Invacare Remote Control displays a Right magnetic brake fault?
If your Invacare Remote Control indicates a right magnetic brake fault, check the cables and connectors. Also, verify that the right magnetic brake is engaged.
What to do if my Invacare Remote Control displays a Left magnetic brake fault?
If your Invacare Remote Control indicates a left magnetic brake fault, check the cables and connectors. Also, verify that the left magnetic brake is engaged.
Provides essential safety instructions and warnings for operating the device.
Covers principles of power wiring and cable securing for safe operation.
Explains how to power the remote up and down and basic operation.
Details how the joystick controls direction and speed of the wheelchair.
Explains how to use the speed dial to adjust maximum speed.
Describes how to perform an emergency stop using the ON/OFF button.
Introduces the operation of powered seating functions.
Details how to switch between different drive functions.
Provides instructions and warnings for charging the batteries.
Guides on how to diagnose faults using the status display.
Lists fault codes indicated by status indicator flashes and their meanings.
Explains the "Out Of Neutral" safety feature.
Describes the drive inhibit mode and its indications.
General| Brand | Invacare |
|---|---|
| Model | LiNX DLX-REM110 |
| Category | Remote Control |
| Language | English |
To Next Page
