What to do if my Invacare LiNX DLX-REM216 Remote Control status display is OFF?
If the status display on your Invacare Remote Control is off, start by checking if the drive electronics system is powered up. Next, verify that all cables are correctly connected. Finally, ensure that the batteries are not discharged.
What to do if my Invacare LiNX DLX-REM216 Remote Control displays a module fault (other than remote module)?
If your Invacare Remote Control displays a module fault (other than the remote module itself), you should: * Check the cables and connectors. * Check the modules. * Recharge the batteries. * If the chair was stalled, reverse away or remove the obstacle.
What to do if my Invacare LiNX DLX-REM216 displays a network or configuration fault?
If your Invacare Remote Control shows a network or configuration fault, begin by checking the cables and connectors. After that, recharge the batteries and check the charger.
What to do if my Invacare Remote Control displays a Drive OON warning?
If your Invacare Remote Control displays a Drive OON warning, return the joystick to the center position.
What to do if my Invacare Remote Control displays Motor 11 fault?
If your Invacare Remote Control displays a Motor 11 fault, check the cables and connectors.
What to do if my Invacare Remote Control displays Motor 21 fault?
If your Invacare Remote Control displays a Motor 21 fault, check the cables and connectors.
What to do if my Invacare Remote Control displays a Left magnetic brake fault?
If your Invacare Remote Control indicates a left magnetic brake fault, check the cables and connectors. Also, verify that the left magnetic brake is engaged.
What to do if my Invacare LiNX DLX-REM216 displays a Right magnetic brake fault?
If your Invacare Remote Control indicates a right magnetic brake fault, check the cables and connectors. Also, verify that the right magnetic brake is engaged.
What to do if the Invacare Remote Control shows a network or configuration error?
If you encounter a network or configuration error with your Invacare Remote Control, first check the cables and connectors to ensure they are properly connected. Then, try recharging the batteries and inspect the charger. If problems persist, it may be necessary to contact your provider.
What should I do if my Invacare Remote Control displays 'Motor 11 error'?
If your Invacare Remote Control displays a 'Motor 11 error', start by checking the cables and connectors to ensure they are properly connected. If the issue persists, contact your provider.
Provides essential safety precautions for operating and maintaining the device to prevent injury or damage.
Details the controls, buttons, and indicators for the DLX-REM110 remote unit.
Details the controls, buttons, and indicators for the DLX-REM211 remote unit.
Details the controls, buttons, and indicators for the DLX-REM216 remote unit.
Procedures for performing an emergency stop and using the horn function.
Instructions for charging batteries and understanding battery status and alarms.
Guide to diagnosing faults using status indicators, flash codes, and diagnosis codes.
General| Connectivity | Bluetooth |
|---|---|
| Operating Range | Up to 10 meters (33 feet) |
| Compatibility | Invacare LiNX Power Wheelchairs |
| Weight | Approximately 100 grams (with batteries) |
| Type | Remote Control |
To Next Page
