What should I do if my Invacare Remote Control displays 'Motor 21 error'?
If your Invacare Remote Control displays a 'Motor 21 error', start by checking the cables and connectors to ensure they are properly connected. If the issue persists, contact your provider.
What to do if the Invacare Remote Control status display is OFF?
If the status display on your Invacare Remote Control is OFF, first check whether the drive electronics system is switched on. Next, verify that all cables are correctly connected. Finally, ensure that the batteries are not discharged.
What to do if I see a 'Module error (other than remote module)' on my Invacare Remote Control?
If your Invacare Remote Control displays a 'Module error (other than remote module)', check the cables and connectors, and verify the modules. Recharge the batteries. Also, if the chair was stalled, reverse away or remove the obstacle. If the issue continues, contact your provider.
What to do if the Invacare Remote Control shows a 'Left magnetic brake error'?
General| Type | Remote Control |
|---|---|
| Compatibility | Invacare LiNX power wheelchairs |
| Display | LCD |
| Function | Control power wheelchair functions |
| Connection | Wireless |
| Battery Type | Lithium-ion |
| Weight | Approximately 200 grams |
| Buttons | Multiple function buttons |
Provides essential safety precautions for operating the device and avoiding hazards.
Provides an overview of setup tasks intended for qualified technicians.
Details procedures for safe and reliable cable installation and routing.
Guides on how to properly connect the remote module to the system.
Explains how to power the remote on/off and use the joystick for control.
Details adjusting maximum speed and performing an emergency stop.
Explains how to switch between different drive functions.
Provides instructions for battery charging, charge states, and alarm conditions.
Guides on diagnosing system faults using fault codes and indicators.
To Next Page
