EasyManua.ls Logo

Invacare orion pro - User Manual

Invacare orion pro
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Orion
Orion
METRO
, Orion
PRO
enScooter
ServiceManual
DEALER:Keepthismanual.
TheproceduresinthismanualMUSTbeperformedbyaqualied
technician.

Questions and Answers

  • D
    douglasjamesAug 9, 2025
    Why my Invacare orion pro Scooter will not start?
    • T
      Tommy ClarkAug 9, 2025
      If your Invacare Scooter isn't starting, there might be several reasons. The batteries could be defective and need replacement, or they might be completely discharged, requiring pre-charging. It's also possible that the power supply to the operating console is interrupted, in which case you should check the main fuse. Another potential cause is a defective operating console; inspect the cable between the modules for loose connections or damage. If the operating console is defective, consider replacing it.
  • C
    Cassandra BushAug 15, 2025
    What to do if Invacare orion pro Scooter batteries not being charged?
    • C
      carrillotimothyAug 15, 2025
      If the batteries of your Invacare Scooter aren't charging, it could be due to a couple of reasons. The batteries themselves might be defective and require replacement. Alternatively, the charger could be defective and also need replacing.
  • J
    Jenna McleanAug 20, 2025
    How to fix Invacare orion pro that runs too slowly?
    • C
      Craig LeeAug 20, 2025
      If your Invacare Scooter is running too slowly, the operating console might be defective, requiring replacement. Another possible reason is that the batteries are defective and need to be replaced.
  • G
    Gail MorrisAug 27, 2025
    Why does my Invacare Scooter judder in drive mode?
    • T
      Troy WiseAug 27, 2025
      If your Invacare Scooter judders while in drive mode, it could be due to defective drive motor(s), which would need to be replaced. Another potential cause is a defective drive lever potentiometer, which would also need replacement.
  • S
    shaffergarySep 1, 2025
    What to do if Invacare orion pro does not reduce speed on bends?
    • O
      oliviabartlettSep 1, 2025
      If your Invacare Scooter isn't reducing speed on bends, the curve control device for bend travel might not be adjusted properly; in this case, adjust the curve control device. Alternatively, the curve control device could be defective and need replacement.

Summary

1 General

1.1 General information

Service and maintenance must follow this manual and safety information. Use original Invacare spare parts.

2 Safety

2.1 Safety and fitting instructions

Essential safety instructions to prevent accidents, including personal safety equipment and general precautions.

3 Hygiene

3.1 Handling of returned used products

Guidelines for manual cleaning and disinfection of returned mobility devices before repair or reconditioning.

4 Service

4.1 General safety information on installation work

Safety precautions for installation work, especially regarding shim rings and potential damage to the mobility device.

4.2 Troubleshooting

Covers operational faults, drive fault diagnosis, and error/diagnostic codes for common scooter problems.

4.3 Tightening torques

Specifies tightening torques for various threads (M4 to M16) for safe assembly and maintenance.

4.4 Service plan (1 x annually)

Annual service checklist covering seat, frames, wheels, brakes, shock absorber, drive units, lighting, and batteries.

4.5 Controls

Procedures for replacing operating console, circuit board, potentiometer, and power module. Includes setup settings.

4.6 Shrouds

Instructions for removing and replacing the mobility device shrouds.

4.7 Lighting unit

Procedures for replacing headlights, front direction indicators, center brake light, and rear lights.

4.8 Wheels

Covers replacing wheel suspension, shock absorber, swing arm, and front axle, plus tire puncture repair.

4.9 Brakes

Instructions for replacing hand brakes and brake cables, including adjustments and testing.

4.10 Drive components

Covers replacing sensors, regulating unit, and the drive unit itself, along with safety precautions.

4.11 Seat system

Procedures for replacing seat suspension/spring and seat support tube, including safety warnings.

4.12 Accessories

A list of available accessories for the Orion scooter and where to find installation instructions.

Invacare orion pro Specifications

General IconGeneral
Maximum Speed12 km/h (7.5 mph)
RangeUp to 52 km (32 miles)
Weight Capacity300 lbs
Total Length132 cm (52 inches)
Weight (Including Batteries)220 lbs
Top Speed12 km/h (7.5 mph)
Range per ChargeUp to 52 km (32 miles)
Weight220 lbs
Overall Length132 cm (52 inches)

Related product manuals