To Next PageTo Next PageWhat to do if JOYSTICK TIMEOUT displays and my Invacare Pronto M71 Wheelchair won't drive?
If JOYSTICK TIMEOUT is displayed and the wheelchair does not drive, it means the joystick or input device is disconnected (Error code 32). Turn the power off, reconnect the joystick or input device, and turn the power back on.
What to do if BAD JOYSTICK CAL VALUES displays and my Invacare Pronto M71 Wheelchair won't drive?
If BAD JOYSTICK CAL VALUES is displayed and the wheelchair does not drive, the joystick calibration values are outside of the expected range (Error code E19). Recalibrate the joystick (joystick throw procedure).
What to do if SPM L Park Brake Fault or SPM R Park Brake Fault displays and Invacare Pronto M71 does not drive?
If either 'SPM L Park Brake Fault' or 'SPM R Park Brake Fault' is displayed and the wheelchair does not drive, the motor lock levers may be disengaged (Error code E9 or E10). Engage the motor lock levers.
Performance| maximum speed | 4.25 mph |
|---|---|
| incline capability | 9˚ |
| minimum turning radius | 21.3" |
| minimum turn-around width | 29" |
Components| front casters | 6" x 2" |
|---|---|
| drive wheels | 10.5" x 3.5" |
| rear casters | 6" x 2" |
| battery type | U1 |
Weight and Dimensions| length with footboard up | 34" |
|---|---|
| length with footboard down | 38" - 40" |
| width | 24" |
| height | 37" - 48" |
| seat width | 16" - 20" |
| seat depth | 16" - 20" |
| back height | 16" - 24" |
| seat-to-floor height | 18" |
| turning radius front | 19.5" |
| turning radius rear | 19.5" |
| ground clearance | 3.8" |
| maximum length | 41" |
| total wheelchair mass | 220 lb. |
Weight| weight with batteries | 200 lb. |
|---|---|
| weight without batteries | 150 lb. |
| weight capacity | 300 lb. |
| weight of van seat (lo-back), arms, seat frame, joystick | 46 lb. |
| weight of battery and cover assembly (each) | 25 lb. |
| weight of battery tray, charger, controller shrouds | 21 lb. |
| weight of side frame, motor gearbox, side shroud (each) | 39 lb. |
| weight of footboard and mounting tube | 5 lb. |
Information for the end user regarding wheelchair selection and use.
Details on factory-installed transport brackets and restraint systems (TRRO/TRBKTS).
Identifies wiring labels for M71 Standard and Formula PTO Plus models.
Illustrates label locations for wheelchairs with or without TRRO.
Specifications and parameters for the Pronto M71 model.
Specifications and parameters for the Formula PTO Plus model.
Guidelines for controller setup, repair, and servicing.
Information on proper wheelchair operation and adjustments.
Information on battery types, recommendations, and care.
Guidance on maintaining wheelchair stability and balance.
Techniques for navigating common obstacles with the wheelchair.
Instructions for safe transfers into/out of the wheelchair.
Safe practices for reaching and bending forward and backward.
Checklists for regular safety inspections of the wheelchair.
Common problems and their solutions for all wheelchairs.
Turning power on/off and using the joystick for driving.
Operating the Formula PTO system, tilt, and drive lock-out.
Overview of different joystick types and their controls.
Procedures for removing, installing, and adjusting van seat arms.
Procedures for installing, removing, and positioning flip back armrests.
How to adjust the back angle for different seat types.
Steps to adjust the headrest and seat height.
Removing/installing seat assembly and adjusting seat position.
Procedures for removing and installing the footboard assembly.
How to adjust the angle and depth of the footboard assembly.
Procedures for installing and removing front riggings.
How to adjust footrest height and center mount footrest angle/height.
How to adjust the footplate angle and flip-up footplate tension.
Procedures for removing and installing wheelchair shrouds.
How to engage and disengage the motor release levers.
Procedures for replacing caster assemblies and adjusting forks.
Safety warnings for battery handling, replacement, and proper use.
Procedures for removing/installing batteries and managing cables.
Instructions for charging batteries and operating the charger.
How to reposition the joystick for different models.
Procedures for disconnecting and connecting the joystick.
Steps for disassembling the wheelchair for transport.
Steps for reassembling the wheelchair after transport.
Information on packages, compliance, and specifications.
Procedures for securing the wheelchair and occupant for travel.
Guidelines for positioning pelvic and torso belts correctly.
