Invacare Reliant 450 RHL450-1

Questions and Answers

R
Ricardo PottsAug 13, 2025
What to do if electric actuator fails to lift when button is pressed on Invacare Reliant 450 RHL450-1?
- J
  James HallAug 13, 2025
  If the electric actuator on your Invacare Medical Equipment fails to lift when the button is pressed, consider these potential causes: * A loose hand-control or actuator connector. * Low battery charge (charge the batteries as described on page 27, or replace the battery pack). * The RED emergency stop button is pressed IN (rotate it CLOCKWISE until it pops out). * The battery is not properly connected to the control box (reconnect as described on page 27). * Damaged connecting terminals. * The electric actuator may need service, or the load is too high.
D
donna77Aug 17, 2025
Why is oil leaking from hydraulics in my Invacare Reliant 450 RHL450-1 Medical Equipment?
- W
  Whitney MooreAug 17, 2025
  If you notice oil leaking from the hydraulics of your Invacare Medical Equipment, it likely means the hydraulic pump needs to be replaced. Contact your Dealer.
J
Jason StephensonAug 21, 2025
What to do if manual / hydraulic pump fails to lift when pumped on Invacare Reliant 450 RHL450-1?
- S
  Stephanie KimAug 21, 2025
  If your Manual/Hydraulic pump fails to lift when pumped on Invacare Medical Equipment, it could be due to the following reasons: * The Control Valve is not fully closed (close the Control Valve). * The Manual / Hydraulic pump needs to be replaced. Contact your Dealer. * There are connection problems (check connections).
K
Kelsey DunnAug 25, 2025
Why is there an unusual noise from actuator in my Invacare Reliant 450 RHL450-1 Medical Equipment?
- J
  Jessica KennedyAug 26, 2025
  If you are experiencing an unusual noise from the actuator of your Invacare Medical Equipment, it's possible that the actuator is worn or damaged, or the spindle is bent. Contact your Dealer.
V
vcohenAug 28, 2025
Why are casters/brakes noisy or stiff on Invacare Reliant 450 RHL450-1?
- S
  Steven ThomasAug 28, 2025
  If the casters or brakes on your Invacare Medical Equipment are noisy or stiff, it is probably due to fluff or debris in the bearings.
S
Samantha AtkinsSep 1, 2025
Why does my Invacare Reliant 450 RHL450-1 patient lift feel loose?
- L
  Larry LowerySep 1, 2025
  If your patient lift feels loose, it could be due to a loose Mast/Base joint or loose Tie-Rods.
H
hartmanjasonSep 4, 2025
What to do if lift arms will not lower in uppermost position on Invacare Reliant 450 RHL450-1 Medical Equipment?
- P
  pbrownSep 5, 2025
  If the lift arms on your Invacare Medical Equipment will not lower in the uppermost position, it is because the lift arms require a minimum weight load to lower from that position. To resolve this, pull down slightly on the lift arms.
R
rachaeljarvisSep 8, 2025
Why is there a noisy or dry sound from pivots on Invacare Reliant 450 RHL450-1 Medical Equipment?
- A
  Andrew YoungSep 8, 2025
  If you hear a noisy or dry sound from the pivots of your Invacare Medical Equipment, it indicates that they need lubrication.