INVENTOR AR5VI-09WiFi User Manual

Page 10 
 Page 9 
Setting vertical angle of air ow
While the unit is on, use the SWING (up-down)
button on remote control to set the direction
(vertical angle) of airow. Please refer to the
Remote Control Manual for details.
While the unit is on, use the SWING (left-right)
button on remote control to set the direction
(horizontal angle) of airow. Please refer to the
Remote Control Manual for details.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set
louver at too vertical an angle for long periods
of time. This can cause water to condense on
the louver blade, which will drop on your floor
or furnishings.
When using COOL or HEAT mode, setting the
louver at too vertical an angle can reduce the
performance of the unit due to restricted air
flow.
CAUTION
Do not put your ngers in or near the blower
and suction side of the unit. The high-speed
fan inside the unit may cause injury.
Fig. A
Setting Angle of Air Flow
Setting horizontal angle of air ow
•
Range
NOTE: Do not move louver by hand. This will
cause the louver to become out of sync. If this
occurs, turn off the unit and unplug it for a few
seconds, then restart the unit. This will reset the
louver.
The SLEEP function is used to decrease
energy use while you sleep (and don’t
need the same temperature settings to
stay comfortable). This function can only
be activated via remote control. And the
Sleep function is not available in FAN or
DRY mode.
Press the SLEEP button when you are
ready to go to sleep. When in COOL mode,
the unit will increase the temperature
by 1°C (2°F) after 1 hour, and will increase
an additional 1°C (2°F) after another hour.
When in HEAT mode, the unit will decrease
the temperature by 1°C (2°F) after 1 hour,
and will decrease an additional 1°C (2°F)
after another hour.
Sleep Operation
•
Set
temperature
1hr
1hr
Keep
running
SLEEP Operation
Saving energy during sleep
Heat mode( -1 C/2 F) per hour
for the rst two hours
Cool mode(+1 C/2 F) per hour
for the rst two hours
For some units, the sleep feature will stop
after 8 hours and the system will keep
running with nal situation.
For some units, the unit will turn off after
7 hours.
Set
temperature
1hr
1hr
7 hours
timer o
SLEEP Operation
Saving energy during sleep
Heat mode( -1 C/2 F) per hour
for the rst two hours
Cool mode(+1 C/2 F) per hour
for the rst two hours
Hold the new
temperature
for 5 hours

INVENTOR AR5VI-09WiFi Specifications

General

Brand	INVENTOR
Model	AR5VI-09WiFi
Category	Air Conditioner
Language	English