13
FP function
LOCK function
O
O
O
O
Keep pressing Fan button for more than 2 seconds to activate/disable Silence
function.
Due to low frequency operation of compressor, it may result in insufficient cooling
and heating capacity. Pressing ON/OFF, Mode, Sleep, Turbo or Clean button while
operating will cancel silence function.
Silence function
Clean
5s
5s
Turbo
Press this button 2 times during one second under HEAT Mode and setting temperature of
16 C/60 F or 20 C/68 F.
The unit will operate at high fan speed (while
compressor on) with temperature automatically
set to 8 C/46 F.
2
+
Press together Clean button and Turbo button at the
same time more than 5 seconds to activate Lock function.
All buttons will not response except pressing these two
buttons for two seconds again to disable locking.
2s
Pressing On/Off, Sleep, Mode, Fan and Temp. button while operating will cancel this function.
Sleep function ( ) :
SET function
or
SET
SET
OK
Press the SET button to enter the function setting, then press SET button or TEMP or TEMP
button to select the desired function. The selected symbol will flash on the display area, press the
OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
The SLEEP function is used to decrease
energy use while you sleep (and don t need
the same temperature settings to stay
comfortable). This function can only be
activated via remote control.
Note:
The SLEEP function is not available
in FAN or DRY mode.
,
For the detail, see sleep operation in
USER S MANUAL.
,
,,
,,
,,
,,
Follow me function ( ):
The FOLLOW ME function enables the remote
control to measure the temperature at its
current location and send this signal to the
air conditioner every 3 minutes interval.
When using AUTO, COOL or HEAT modes,
measuring ambient temperature from the
remote control(instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature around you and
ensure maximum comfort.
If the memory feature is stopped, OF
displays for 3 seconds on the screen.
While the memory feature is activated,
press the ON/OFF button, shift the mode
or power failure will not cancel the Follow
me function.
NOTE: Press and hold Turbo button for
seven seconds to start/stop memory
feature of Follow Me function.
If the memory feature is activated,
On
displays for 3 seconds on the screen.
AP function ( ) :
Choose AP mode to do wireless network
configuration. For some units, it doesn’t
work by pressing the SET button. To enter
the AP mode, continuously press the LED
button seven times in 10 seconds.
“ ”
“ ”
Press the SET button to scroll through operation functions as follows:
Breeze Away ( ) Fresh ( ) Sleep( ) Follow Me( ) AP mode( )
[ ]: If your remote controller has Breeze Away button, Fresh button or Sleep button, you can not
use the SET button to select the Breeze Away, Fresh or Sleep feature.
* *
*
FRESH ( ):
When the FRESH function is initiated,
the UV-C lamp and the ion generator are
energized and will help to purify the air in
the room.
Breeze Away function (
):
This feature avoids direct air ow blowing
on the body and makes you feel indulging in
silky coolness.
NOTE: This feature is available under Cool,
Fan and Dry mode only.
To Next Page
Loading...
Need help?
General
