INVERSilence Tech B+InverSilence15 - Maintenance

10
Note:
1. AL01 is not an error indication: when it appears the inverter will automatically switch to a
lower capacity to self protect against high internal temperature. When the temperature drops
back to 68℃ the inverter will resume at the preset speed.
2. When causes for E002/E101/E103 lifts, the device will resume working automatically,
however when it appears a fourth time, the device will stop working, to resume operation,
unplug the device and plug in & restart again.
10. MAINTENANCE
Item
Code
Description
Analysis
1
E001
Abnormal input voltage
Not faulty
2
E002
Output over current
Not faulty
3
E101
Heat sink over heat
Contact your supplier
4
E102
Heat sink sensor error
Contact your supplier
5
E103
Master driver board error
Contact your supplier
6
E201
Circuit board error
Contact your supplier
7
E202
Master board EEPROM reading
failure
Contact your supplier
8
E203
RTC time reading error
Contact your supplier
9
E204
Display board EEPROM reading
failure
Contact your supplier
10
E205
Communication error
Contact your supplier
11
AL01
Auto speed reduction against
high temperature
Contact your supplier