INVOLLY OL381C - Operating Instructions; Laminator Operating Steps

Laminator Operating Steps:
Specifications
Operating Instructions
1. Insert the power plug into the appropriate voltage and frequency.
2. Turn the power switch ON, the Power red indicator lights up.
3. Select the lamination mode COLD or HOT.
● HOT Mode: The machine will preheat for 3-4 minutes, when the Ready green indicator lights up, you can
start laminating.
● COLD Mode: The machine would not heat up, only rollers rotate for cold lamination. The Ready green
indicator lights up once you choose this mode. But it only works after the machine is completely cooled.
4. Put your photo or paper into laminating pouch.
5. Insert the laminating pouch from the sealed edge straightly into the laminator.
6. Operation complete, take out the laminated photo or paper.
Product Dimensions( L x W x H)
Product Weight
Voltage
Warm Up Time
Lamination Width
Lamination Speed
Lamination Thickness
Roller
Max Cutting Capacity for Cutter
Max Cutting Capacity for Corner Rounder
ABS
Switch
LED
47 x 17 x 6 cm
2.4 kg
120V 60Hz (US), 220-240V 50Hz (EU)
3-4 minutes
Max. 330mm (A3)
230mm/min
150(2x75)-250(2x125)mic, < 0.5mm
2 Rollers
8 sheets 80g A3 Paper
3 sheets 80g Paper
Manual
ON/ OFF, COLD/ HOT
Power, Ready
EN
02