BPD series PV pumping inverter Fault diagnosis and solution
51
The water storing tank is full.
If the water full alarm function is
enabled, the device
automatically stops after the
water full alarm remains for a
certain period of time, and no
processing is needed. If the
water full alarm function is not
enabled, check whether there
are terminals misconnected.
The water pumping tank is
empty.
1. If the water empty alarm
function is enabled, the device
automatically stops after the
water empty alarm remains for a
certain period of time, and no
processing is needed. If the
water empty alarm function is
not enabled, check whether
there are terminals
misconnected.
To Next Page
Loading...
