Need help?Do you have a question about the INVT GD20-015G-4 and is the answer not in the manual?
General| Power | 15kW |
|---|---|
| Protection Level | IP20 |
| Cooling Method | Forced air cooling |
| Control Method | V/F control |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overload, Overheat, Short circuit |
| Communication Interface | RS485 |
| Operating Temperature | -10°C to +50°C |
| Storage Temperature | -20°C ~ +60°C |
| Humidity | 5% to 95% (non-condensing) |
| Altitude | Below 1000m |
Defines 'Danger', 'Warning', 'Note', and 'Qualified electricians' for safety.
Explains symbols used for warnings, including Danger, Warning, Do not touch, Hot sides.
Provides guidelines for safe operation, wiring, and component handling.
Covers safety during delivery, installation, and material handling.
Details safety precautions for starting, operating, and stopping the inverter.
Outlines safety procedures for maintenance and replacing parts.
Guides users through initial setup, unpacking, and application confirmation.
Details electrical specifications like input voltage, current, output power, and frequency.
Specifies environmental conditions required for optimal inverter performance.
Provides main circuit connection diagrams and terminal descriptions.
Illustrates wiring diagrams and terminal functions for control circuits.
Explains protection measures for the inverter and cables against short circuits.
Configures protection functions against phase loss, overvoltage, and current limits.
Configures Modbus communication parameters like address and baud rate.
Lists recommended inspection and maintenance schedules for inverter components.
Guides users on identifying, diagnosing, and resolving inverter faults.
Introduces Modbus protocol, its modes (ASCII, RTU), and network structure.
Illustrates command codes (03H, 06H, 08H, 10H) and data formats for RTU/ASCII.
Identifies common communication issues and their potential causes.
To Next Page