iMars grid-tied solar inverters Installation
21
(6) The inverter should be installed on firm and solid surface such as wall surface and metal
bracket.
(7) The installation surface should be vertical to the horizontal line, as shown in Figure 4.4.
(8) The installation should ensure that the inverter is reliably grounded, and the material of
grounded metal conductor should be consistent with the metal material reserved for the
grounding of the inverter.
Install the inverter vertically or backward ≤ 15° to facilitate heat dissipation.
Do not tilt the inverter forward, horizontal, upside down, over- backward, and roll when install the
inverter.
Figure 4.4 Installation position of the inverter
Do not open the surface cover of the inverter or replace any part as incomplete
inverter may cause electric shock and damage the device during operation.
4.2.3 Specification of cable
In order to regulate and compatible with the inverter AC/DC connector or wiring terminal
specifications, below requirements on the AC/DC cable connected to corresponding inverter
models should be fulfilled:
To Next Page
Loading...
