iMars grid-tied solar inverters Monitoring communication
56
Figure 7.2 RS485 pin on inverter Figure 7.3 Communication connector
Connection steps:
(1) Connect the communication connector configured for the inverter to the RS485 terminal of
the inverter, as shown in Fig 7.4;
(2) According to Table 7-1, connect the communication connector pinout and the user's
device, make sure the connection is correct.
Figure 7.4 Communication cable connection
(3) Please download the monitoring software “iMars WinExpert” and its operation instruction
from our website.
To Next Page
Loading...
