EasyManua.ls Logo

IO Mabe IO930 - Burner and Ignition Problems

IO Mabe IO930
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
87
Excessive
smoking
during broiling
Food too close to burner
element.
Lower the rack position of the food.
"LOCK DOOR"
flashes in the
display
The Self-Clean or
Steam-Clean cycle has
been selected but the
door is not locked.
Lock the oven door.
"F—and a
number or
letter" flash in
the display
There is a function error
code.
Press the Cancel/Off pad. Allow the
oven to cool for one hour. Put the
oven back into operation. If the
function code repeats, disconnect all
power to the oven for at least 30
minutes and then reconnect power. If
the function error code repeats again,
call for service.
Oven door will
not open
The oven door is locked
because the temperatu-
re inside the oven has
not dropped below the
locking temperature.
Press the Cancel/Off pad. Allow the
oven to cool below the locking
temperature.
Oven door will
not open
The oven door is locked
because the temperatu-
re inside the oven has
not dropped below the
locking temperature.
The oven door is locked because the
temperature inside the oven has not
dropped below the locking tempera-
ture.
Clock flashes due
to a power
outage
Power outage or surge. Reset the clock. If the oven was in use,
you must reset it by pressing the
Cancel/Off pad, setting the clock and
resetting any cooking function.
Lock controls or
Control Lockout
feature is
activated
If LOC ON appears in the display, the
range control is locked. Turn this
feature off to use the range. See the
Oven Controls section.
Problem Possible cause What to do
Gas supply not connec-
ted or turned on.
See the installation Instructions that
came with your range.
Burners do not
light
Plug on range is not
completely inserted in
the electrical outlet.
Make sure electrical plug is plugged
into a live, properly grounded outlet.
A fuse in your home
may be blown or the
circuit breaker tripped.
Replace the fuse or reset the circuit
breaker.
Burner parts not
replaced correctly.
See the Care and Cleaning of the
range section.

Related product manuals