To Next Page

To Previous Page

Upgrade Fail

If you don’t see “Firmware upgrade OK” in the “Status Messages” window, it means the

utilityhasfailedtocompletethermwaresuccessfully.Ifthatoccurs,pleasedothefollowing:

Step 1

UnplugthepowerfromtheKVM.Then,connecttheprovidedrmwareupgradecabletothe

rmwareupgradeportoftheKVMandtheserialportofyourcomputer.

Step 2

Slide the Firmware Upgrade Recovery Switch to the Recover position (slide to the right).

Then, connect power adapter back to the KVM.

Step 3

Repeatthermwareupgradeprocess.(PleaserefertoFirmwareUpgradesection)

Step 4

Afterthermwareupgradehascompleted,theKVMwillresetitself.Unplugthepowerfrom

the KVM after the KVM is reset.

Step 5

Slide the Firmware Upgrade Recovery Switch back to the Normal position (slide to the left).

Then, connect power adapter back to the KVM.

Final Step

Now the KVM is ready to function again, so you simply reconnect all your computers and

console back to the KVM and begin using the KVM.

IOGear GCS1108 User Manual

Questions and Answers: