Plug in the power adapter. The following directions appear on the KVM console screen.4.
USERNAME AND PASSWORD INFORMATION AND PORT/USER INFORMATION HAS BEEN CLEARED.
PLEASE POWER OFF THE SWITCH, REMOVE THE JUMPER, CLOSE THE CASE AND RESTART.
Unplug the power adapter again.5.
Remove the jumper cap from pins 1-2 of the J17 jumper.6.
Replace the cover on the KVM switch.7.
Plug in the GCS1716 power adapter.8.
You should now use the default username and password to log in to the GCS17169.
To Next Page
Loading...
