Iomega CD-RW USB 2.0 Drive - Drive Not Assigned a Letter (Windows 2000;XP); Green Power Light Does Not Come On

12. Check your BIOS to ensure USB is enabled. Refer to your computer's User's Guide or manual for directions.
NOTE:
If you disconnect your Iomega CD-RW USB drive and reconnect to the same USB port, the drive should be reassigned the same drive letter automatically. If you reconnect
to a different USB port, you may have to manually reassign the drive letter.
If the problem continues, there may be a driver conflict on your system. Please contact the Iomega web site (www.iomega.com) or go to the How To Get Help section and call our
Automated FaxBack help for additional troubleshooting information.
The Iomega CD-RW Drive Is Not Assigned a Drive Letter Under Windows 2000 or Windows XP.
1. Check all connections.
2. Make sure the Iomega CD-RW USB drive is receiving power.
3. Make sure you are using the Iomega CD-RW USB cable that came with your Iomega CD-RW drive.
4. If you are using a USB 2.0 card, check Device Manager to verify that the card is installed and working properly.
5. If you are connected to a USB hub, ensure the hub is connected properly and has power.
6. Try connecting the Iomega CD-RW USB drive directly to one of the USB connections on your computer, rather than a USB hub or keyboard.
7. Try manually assigning a drive letter to the Iomega CD-RW USB drive:
NOTE:
You must have administrator privileges for your local computer in order to change drive letters under Windows 2000.
a. Select
Control Panel
,
Administrator Tools
,
Computer Management
, then
Disk Management
.
b. Right click the icon for the Iomega CD-RW USB drive and select
Change Drive Letter and Path
from the shortcut menu.
c. Click the
Edit
button.
d. Click
Assign a drive letter
and select the letter you want to use for your Iomega CD-RW USB drive.
e. Reboot the system.
Green Power Light Does Not Come On.
1. Make sure you are using the Iomega universal power supply that came with your Iomega CD-RW drive. Ensure that it is connected to the Iomega CD-RW drive as shown in
the instructions for connecting your drive.
2. Verify that the power supply connector is completely inserted into the Iomega CD-RW drive power connector.
3. Verify that the power supply is plugged into a working power outlet.