Iomega CD-RW USB 2.0 Drive - Getting Started; Unpacking and Initial Setup; Upgrading from Windows 98 to Windows Me;2000;XP

To Next Page

To Previous Page

Pentium

166 or higher with built-in USB controller (some USB controllers or motherboards might not support all types of USB devices)

Microsoft

Windows

98, 98SE, 2000, Me, NT or XP

Sound Blaster

compatible sound card for audio playback

Upgrading from Windows 98 to Windows Me/2000/XP

If a previous version of Iomega CD-RW software is installed on your system, remove it before installing Windows Me/2000/XP. Use

Add/Remove Programs

in Control Panel,

uninstall all the Iomega CD-RW software, then restart Windows. Install Windows Me/2000/XP according to the instructions included with the Windows Me/2000/XP package. Install

the Iomega CD-RW software included with your Iomega drive after the Windows Me/2000/XP installation is complete. See Installing Iomega CD-RW Software for help installing the

Iomega software.

Getting Started

IMPORTANT:

To operate the Iomega

CD-RW drive at USB 2.0 speeds, you will need to purchase and install a USB 2.0 adapter card.

Before installing or using your Iomega CD-RW drive, read and follow the USB guidelines to ensure reliable performance from your USB drive.

Here's how to get started using your Iomega CD-RW drive:

1. Unpack the Iomega CD-RW drive and accessories.

Software Size

Iomega HotBurn 10 MB

MusicMatch

Jukebox