Windows NT
®
Users:
You may need to run SetupNT.exe twice from the Windows NT Install
diskette – once to install the Iomega Zip IDE /ATAPI driver, the second
time to install ToolsNT software. Reboot the system after installing the
Zip ATAPI driver and before installing the ToolsNT package.
M IMPORTANT! You must have administrator privileges for your
local computer in order to install software drivers under Windows
NT. You must also have administrator privileges for your computer
to run the ToolsNT utilities. M
Installing Iomega Software under Windows NT 4.0:
1. Run a:\setupnt.exe from the Windows NT Install diskette.
• If the SetupNT program is unable to locate the “tools” disk, make
sure it is fully inserted and click “OK.” If SetupNT is still unable to
locate the “tools” disk, click “OK” again and SetupNT will
automatically open the “SCSI Adapters” Control Panel so that you can
install the Iomega Zip IDE/ATAPI driver.
**
Continue to step 2.
M
**
NOTE: Windows NT installs drives or adapters that use the
IDE interface as SCSI adapters. M
• If the necessary driver is already present on the system, SetupNT
will be able to locate the “tools” disk and install ToolsNT software.
After Windows NT reboots, the Zip ATAPI drive will be ready to use.
2. Select the “Drivers” tab and click the “Add” button.
3. When the list of Iomega adapters appears, double-click the Iomega
Zip IDE/ATAPI driver.
4. Choose “Current” in the Windows NT dialog box. Windows NT
will then add the necessary driver to the list of installed drivers found
on your system.
5. At the next Windows NT dialog box, select “Yes” to reboot the
system. Remove the Install diskette from the floppy drive while
Windows NT reboots.
6. After Windows NT reboots, run SetupNT again from the Install
diskette to install the ToolsNT software package.
M IMPORTANT! If the SetupNT program still cannot locate the
“tools” disk, refer to the NTReadme.txt file on the Install diskette for
instructions on manually installing the driver. M
10