Ionic-CARE TRITON X6 - Setting and Operation; Unit Settings; Operating the Unit

6
SETTING
Main switch – the main switch button serves for the unit switch-on and –o and for the required
power setting.
Indication
, full power, average power input 9 W, maximum power input 12 W – recommended for
great rooms or places with great dustiness up to 75 m
2
*; the unit works without interruption in this mode.
Indication , medium power, average power input 7 W – recommended for medium-sized rooms
up to 50 m
2
where windows and doors are seldom open; in this setting, the unit mode is 20 seconds of
operation and 20 seconds of rest.
Indication , low power, average power input 5 W – recommended for small rooms up to 15 m
2
.
It is the most energy-saving setting. The unit mode is 20 seconds of operation and 120 seconds of rest.
* At standard ceiling height of 2.5 m
Indication
– if the red warning light lights up, it signals one of the following potential problems:
• Voltage variation in the electric network – restart the unit
• Excessively polluted lter which is no more able to capture impurities – clean the stainless lter
• Disorder; the unit does not work correctly – contact the service centre
Useful tip: In general, the mode
is most economical and best for small rooms.
The mode
delivers maximum power and is good for great rooms.
Note: If the unit is plugged in the socket, it consumes electrical energy of approximately 0.080 kWh/day, i.e. about CZK 15/month, even if it is
switched o. In case of your long-term absence, the unit unplugging from the electric network is recommended.
OPERATION
Set the air inlet in a way described in section Preparing for the Unit Start. Press the main switch to start the
unit operation. The unit will purify, ionize, and circulate the air automatically according to a pre-programmed
cycle. Select the required power level by repeated pressing of the main switch button. The setting switches
cyclically between (full power), (medium power), (low power) and switched o. LED indicators
will light according to the power set by you.
The stainless lter of the air purier and the ionizing wires must be cleaned every 4-7 days of use at
least (for the complete procedure, see section Cleaning and Maintenance). After thorough drying of
the stainless lter, its insertion in the unit, and cleaning of ionizing wires, the unit should operate again
without any problems. If not, proceed according to section Problems Solving.
Our tip – watch the video manual!
You can watch the video manual for Ionic-CARE Triton X6 here or at
www.ionic-care.cz/fotogalerie