8
Hard Drive Installation
(For Diskless Version Only)
Did you purchase your 214 preloaded with Hard Drives?
Skip to “Setup an ioSafe 214”on page 23. This section shows
how to install hard drives into an 214
Tools and Parts for Hard Drive Installation
Needed:
A Phillips screwdriver
3mm Hex Tool (included with the ioSafe 214)
At least one 3.5” SATA hard drive
(Please visit http://iosafe.com/support-2baynas
for compatible hard drive models.)
Note: For a RAID1 set, it is recommended that all installed drives be the same size to make the best use of hard disk
capacity.
Warning: If you install a hard drive that contains data, the 214 will format the hard drive and erase all data. If you need
the data in the future, please back it up before installation.
To Next Page
Loading...