IOtech Digital488 - Available Accessories1.2

Section 1 Introduction
1.2
1.2 Available Accessories
Additional accessories that can be ordered for the
Digital488
include:
CA-7-1
1.5 foot IEEE 488 Cable
CA-7-2
6 foot IEEE 488 Cable
CA-7-3
6 foot shielded IEEE 488 Cable
CA-7-4
6 foot reverse entry IEEE 488 Cable
CA-8-50
† 6 foot, 50 conductor ribbon cable with a card edge
connector on one end, the other end un-terminated.
CN-6-50
† 50 Pin solder tab edge connector.
CN-20
Right Angle IEEE 488 adapter, male and female
CN-22
IEEE 488 Multi-tap bus strip, four female connectors in
parallel
CN-23
IEEE 488 panel mount feed-through connector, male
and female
110-0920
Additional Instruction Manual
Rack488-3
† 5-1/4" by 19" rack mount for one
Digital488
Rack488-4
† 5-1/4" by 19" rack mount for two
Digital488
s
TR-2
† 110 volt Wall mount power supply for the
Digital488
TR-2E
† 220 volt Wall mount power supply for the
Digital488
TR-5
110 volt Wall mount power supply for the
Digital488OEM
TR-5E
220 volt Wall mount power supply for the
Digital488OEM
†
For use with Digital488 Only