IOtech Digital488 - Terminator Yn

To Next Page

To Previous Page

Section 3 Command Descriptions

3.29

Terminator Yn

The IEEE 488 bus terminator defaults at power-on to the settings on Switch S1 It

also may be programmed for any combination of Carriage Return (CR) and Line Feed (LF).

The

mode is the most commonly accepted terminator, CR-LF.

reverses the

sequence to send LF-CR.

sends CR only and

sends LF only.

CR LF

LF CR

CR only

LF only

Example:

CLEAR 718

OUTPUT 718;"Y3X"

select line feed terminator