IOtech Digital488 - Inhibit (Qn)

To Next Page

To Previous Page

Section 3 Command Descriptions

3.19

Inhibit Qn

The

Inhibit

control command allows software control of the

Inhibit

line,

independent of any other I/O activities. The 'set' and 'clear' levels of the

Inhibit

line are

determined by the

Invert

command.

Clear the

Inhibit

line (return to unasserted state)

Set the

Inhibit

line (place in the asserted state)

Example:

CLEAR 718

reset the

Digital488

OUTPUT 718;"Q1X"

set the Inhibit line