Copyright © 2020 IoTecha Corp. All rights reserved.
51
c. A pulsing blue LED shows that charging is temporarily paused. Wait for charging to restart
and complete. Charging is complete when the LED shows steady green.
3. Charging is complete. Remove the cable from the vehicle, wrap it around the outside of the
charger, and place the charge coupler in the holder on the side of the charger.
Authentication after connecting the charging cable
1. Connect the cable to the vehicle following the instructions provided by the vehicle manufacturer.
a. While the charger is establishing the power connecting, the LED shows pulsing white.
b. When the LED shows blinking white, the charger is ready for user authentication.
2. To authenticate the use of the charger, hold or touch the RFID card over the LED until the LED
shows rotating white.
a. If the authentication fails, the LED shows steady orange. Unplug the vehicle and re-plug.
b. When the authentication is successful, the LED shows pulsing white.
c. Charging begins. The LED shows pulsing green. When charging is complete, the LED
changes to steady green.
To Next Page
Loading...