IPCO STUDIO 3000 User Manual

STUDIO 3000
OPERATING INSTRUCTIONS
MANUFACTURED
IN THE UK
The Studio 3000 is a combined Programmer and Temperature Controller which
has been specifically designed for use with pottery kilns. Control of the entire
firing cycle is fully automatic, to provide simply set, accurate and repeatable
firings. The creation and progress of a firing program can be easily followed using
the Mimic Display.

IPCO STUDIO 3000 Specifications

General

Category	Controller
Input Voltage	24 VDC
Output Voltage	24 VDC
Protection Class	IP20
Operating Temperature	0-50°C

Summary

Important Safety and User Information

Installation and Setup

Mounting and Connection

Covers mounting the controller and vital electrical installation, including thermocouple matching.

Safety and Declaration

Recommends safety systems for unattended firings and states compliance with European Standards.

Troubleshooting and Support

Guides users on initial troubleshooting steps and contacting suppliers for issues.

Security Lock Features

Setting and Operating Security Lock

Two and Three Zone Control

Setup and Control Tuning for Multi-Zone Kilns

Electrical Connections

Incoming Supply and Thermocouple Wiring

Control Outputs and Option Wiring

Controller Configuration Settings

Thermocouple, Setpoint Limit, and Control Strategy

Zone Control Tuning Parameters

Troubleshooting Common Problems

Display, Thermocouple, and Program Issues

Resolving issues related to display, thermocouple errors, and program start/modification problems.

Firing, Damper, and Lock Problems

Diagnosing causes for kiln firing problems, damper operation, and security lock activation.