iPower AWP80 - 10. Troubleshooting; Engine Issues

29
10. TROUBLESHOOTING
ENGINE
Engine Lacks
Power
Possible Cause Correction
1. Check air filter. Air filter clogged.
Clean or replace filter
(p. 22).
2. Check fuel.
Bad fuel; pump stored
without treating or draining
gasoline, or refuel with bad
gasoline.
Drain fuel tank and
carburetor (p. 26) .
Refuel with fresh
gasoline (p. 20).
3. Take engine to an
authorized servicing
dealer, or Refer to
shop manual.
Fuel filter clogged,
carburetor malfunction,
ignition malfunction, valves
stuck, etc.
Replace or repair
faulty components as
necessary.
Engine Will Not Start Possible Cause Correction
Fuel valve OFF.
Move fuel valve lever to
ON position.
Choke open.
Move choke lever to
CLOSED position
unless engine is warm.
1. Check control
positions.
Ignition switch OFF.
Turn ignition switch to
ON.
Out of fuel. Refuel (p. 20).
2. Check fuel.
Bad fuel; pump stored
without treating or
draining gasoline, or
refuel with bad gasoline.
Drain fuel tank and
carburetor (p. 26).
Refuel with fresh
gasoline (p. 20).
Spark plug faulty, fouled,
or improperly gapped.
Gap or replace spark
plug (p. 22).
3. Remove and
inspect spark plug.
Spark plug wet with fuel
(flooded engine).
Dry and reinstall spark
plug. Start engine with
throttle lever in FAST
position.
4. Take engine to an
authorized servicing
dealer, or refer to shop
manual.
Fuel filter clogged,
carburetor malfunction,
ignition malfunction,
valves stuck, etc.
Replace or repair faulty
components as
necessary.