-34-
c. Click the Connect button to start WPS function of the
camera.
d. You need to enter the PIN Code displayed on the camera
to the router (or access point) within 120 seconds to
complete the setup.
- PBC Mode: The PBC (Push-Button-Configuration) mode
builds the connection by simply pressing a button on the
device.
a. Click the PBC Mode option.
b. Click the Connect button to start WPS function of the
camera.
TIP Instead of clicking the Connect button of Configuration
Utility, you can press the WPS button if the camera is
designed with a hardware button of WPS function.
c. You need to press the WPS button on the router (or
access point) within 120 seconds to complete the setup.
Device Status
Display the WPS configuration of the camera.
TIP The Power LED indicates the WPS connection status by:
- blinking 3 times when the connection is built successfully.
- repeating 3 times of short-short-long blink when the
connection is failed.
To Next Page
Loading...
Need help?
General
