iRest A305 - Page 10

16
17
·When the massage chair is turned on or in standby mode, say “Alice Alice” to wake
up the voice control function.
·After the successful wake-up, the massage chair will reply “I am here”. At this time,
the voice control entry corresponding to the function is realized within 6 seconds.
After the massage chair is respond, the corresponding voice control function can be
realized; if did not correctly say any voice entry for more than 6 seconds, the voice
control function automatically turns off and needs to be reawakened.
·Note: When waking up the voice control function, please use Mandarin, the speech
rate is moderate, Voice commands should be follow up the Voice entry.
4.Voice control operation
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Voice control enter
Awakening words: “hi Alice”. Answer: I am here.
Serial No
Voice control entry
Massage on
Massage close
Comfort Massage.
Relax massage.
Full body massage.
Neck and shoulder massage.
Back and waist massage.
Stretch massage.
Fixed massage.
Change the other mode.
Go little down.
Go little up.
Open the air pressure.
Close the air pressure.
Up the seat position.
Down the seat position.
Stop adjustment.
Answer entry
Answer: Ok, massage on.
Answer: Ok, massage close
Answer: ok, comfort massage
Answer: ok, relax massage
Answer: ok,full body massage
Answer: ok,Neck and shoulder massage
Answer: Ok,back and waist massage
Answer: ok,stretch massage
Answer: ok,fixed massage
Answer: Ok, change the other mode
Answer: Ok, go little down
Answer: Ok, go little up
Answer: OK, Open the air pressure
Answer: OK , Close the air pressure
Answer: Ok, Up the seat position
Answer: Ok, Down the seat position
Answer: Ok, stop adjustment
Method of usageMethod of usage
1.Enter the smart device manual and open the Bluetooth function to search the new
Bluetooth devices .
2.Will find the bluetooth named like (IMCM-XXXX),choose it to pair with the chair .
3.Turn on the Music Player in the smart device .
5.Bluetooth Player Operation
6.Turn off the power and stop massage.
·When pressing the power button during the massage, it will stop all the massage
functions immediately, the backrest and footrest will go back to the default posit
on.And when the massage time up, the massage hand will go back to the default
position, all the massage function will stop, the backrest and footrest will not go
back to the default position.
·Cut off the power of the whole machine. Figure (switch power off)
FUSE:
T5AL 250V
POWER INPUT
CONTROLLER JACK
ON/ OFF
Diagram of the power switch position
Unplug the power cord
7.The calf installation.
·After connecting the wires and the air hose between the chair seat and the leg
rest , unfasten the fixed pipe belt and insert the connecting part into the seat
frame(figure 1).
·Place the round tube from calf left and right sides to the legs brackets.(figure 2)
1 2