Need help?Do you have a question about the iRig Mic Cast 2 and is the answer not in the manual?
Register to access technical support, warranty, and receive JamPoints ootnotemark[1] for discounts.
Fix the metal plate on your device or case for magnetic mounting of the microphone.
Attach the iRig Mic Cast 2 to the plate using magnets and connect to your device via TRRS cable.
Download and launch the iRig Recorder app from the App Store or Google Play.
Enable Airplane Mode and Do Not Disturb to prevent audio interruptions during recording.
Use the 3-position switch to choose between front, rear, or dual capsule polar patterns.
Connect headphones to the iRig Mic Cast 2 output for audio monitoring and volume control.
Attach the included wind shield to minimize environmental noise for clearer recordings.
Use Airplane Mode and place mic away from Wi-Fi/Bluetooth to reduce radio interference.
Ensure your app supports audio pass-through for headphone output monitoring.
Handle with care; slide to detach the microphone from the magnetic plate.
Use provided plates; avoid attaching to rigid metal structures to prevent damage.
Select single cardioid (front/rear) or dual omnidirectional patterns for optimal audio capture.
Adjust app gain or move closer to the sound source for louder recordings.
Move microphone away from the sound source or adjust app gain for distortion-free audio.
Verify that the app enables audio-through from input to output for headphone monitoring.
Enable Airplane Mode and disable Wi-Fi to reduce noise from RF interference.
Details on the warranty policy and where to find the complete terms online.
Links to further support resources and additional product information on the IK Multimedia website.
General| Type | Condenser |
|---|---|
| Polar Pattern | Cardioid |
| Frequency Response | 20 Hz - 20 kHz |
| Output Connector | 3.5mm TRRS |
| Compatibility | iOS, Android, Mac, PC |
| Maximum SPL | 120 dB |
| Power Source | Plug-in power |
| Cable Length | 1.2 m |
To Next Page