11
→
Cleaning and maintenance
●
Before cleaning and maintaining,
charging adapter.
●
Do not spray with water. Doing so
may result in electrical shock, injury
or malfunctioning.
●
Do not use cleaners, thinners, benzene, bleach, etc.
●
Do not use chemically treated dust cloths.
■
Mop head, Shaft, Operating
handle
• Refer to the method for removing (P7), and then
remove the mop head, the Shaft, and the operating
Handle, fully wring out a soft cloth which has been
dampened with cool or warm water (no warmer
• I
-
-
ened with a diluted neutral kitchen cleaning agent. Then
fully wring out the cloth so that there is no cleaning
■
Pad attachment surface
If dust or dirt accumulates on the attachment surface
part of the mop pads, the attachment surface will
easily. If dust or dirt accumulates, use a toothbrush or
something similar to remove it.
※
If there is water in the water reservoir, that water
and maintaining.
●
When holding and moving the mop
head with water in the water res-
ervoir, make sure not to tilt. Or the
water may spill out and cause mal-
functioning.
■
How to drain the water from
the water reservoir
!
Open the water reservoir, tilt the mop
head, and drain out any water remaining
in the water reservoir
#
Press the water spray button several
times to get all of the water out
Press
■
Nozzle
If the nozzle gets clogged up, use the attached pin for
cleaning nozzle to clean it out.
To Next Page
Loading...