19
Wireless Charging Pad Instructions
Your IrisVision will take approximately 5 hours to fully
charge and will automatically return to Focus mode when
powered on.
NOTES:
• Please make sure that your headset is powered on and
the Display Unit is installed into the headset.
• The headset does not go to sleep in Television mode.
Charging while in Television mode is not recommended.
1. Plug the Wireless Charging Pad into an electrical outlet.
2. Center the IrisVision headset face down on the wireless
Charging Pad. If voice prompts are enabled, you will
hear a verbal prompt, and a solid red light will illuminate
on the charging pad when the headset is properly
placed on the charging pad.
3. If you DO NOT hear this tone or see any illumination:
• The headset contains a proximity sensor to
determine if it is in use. Please place the straps
outside of the headset while it is charging to
ensure that the sensor is not activated.
• Remove the Display Unit from the headset and
place the back of the Display Unit (not the screen)
directly onto the pad instead. For instructions on
removing the Display Unit, see page 13.
The screen will turn black few minutes after you set the
headset on the charger. When the Display Unit is fully
charged, the red light on the charging pad changes to green
and you will hear a verbal prompt, “Charging completed” (if
voice prompts are enabled).
To Next Page
Loading...
