41
Adjusting Volume
• Say “Set volume to <number>” to set volume to a
specific level (1 to 15) Example: Say “Set volume to
10”.
• Say “Increase volume” to increase volume by 1
(maximum 15).
• Say “Decrease volume” to decrease volume by 1
(minimum 1).
• Say “Max volume” to set volume to the highest level.
• Say “Low volume” to set volume to the lowest level.
Adjusting Contrast
• Say “Set contrast to <number>” to set contrast to a
specific level (1% to 100%).
• Say “Increase contrast” to increaser contrast by 5%.
• Say “Decrease contrast” to decrease contrast by 5%.
• Say “Max contrast” to set contrast to the highest level.
• Say “Low contrast” to set contrast to the lowest level.
• Say “Reset contrast” to set contrast to 50% (default).
Adjusting Text-to-Speech Speed (applies to all
modes)
• Say “Increase speed” to increase the speed of the
readout.
• Say “Decrease speed” to decrease the speed of the
readout.
To Next Page
