IriSys IRI 1011 - Page 9

IPU 40060 Issue 9
Page 9 of 27
• Emissivity – The user can select the emissivity for the material being
imaged. Setting the correct emissivity value is important to achieve the
accuracy of temperature readings, see note 3 in Section 3.1.
• Colour Map – The user can select one of three possible colour
options:
o Greyscale
o Red-Blue
o Green-Blue
• Integration – The number of image frames to be integrated can be set
to ‘Integration OFF’ or up to 10 frames. Note that this function reduces
“noise” on the image; it should be turned off when imaging a moving scene.
• Temp. Units – The user can select the temperature units to be:
o Celsius (
o
C)
o Fahrenheit (
o
F)
o Kelvin (K)
• Interpolate – The user can select a displayed resolution, of 16x16 pixels or
96x96 pixels.
• 2
nd
Element – The user can select whether to have the second (SP2)
temperature cursor displayed on the screen.
• Continuous Auto – See section on ‘Auto’ above for further explanation.
Figure 7: Tools menu within the IRISYS 1011 Imager software.
Browse
Gives access to five other buttons:
• Prev – Loads the previously stored snapshot file.
• Next – Loads the next stored snapshot file.
• Delete – Deletes the current snapshot. The user will be asked ‘Are you
sure? Yes/No’.
• Tools – Takes the user back to the ‘Tools’ Menu, (see Tools above).
• Live – Returns the user to Live imaging mode.
Exit
Shuts down the IRISYS 1011 Imager software application.
Integration Toggle
Temperature Units
Image Label
Image Folder
Ambient
Temperature
Emissivity
Calibration File
Colour Map
Interpolate Toggle
2
nd
Element Toggle
Continuous Auto