6 For more information, visit global.irobot.com
EN
1
1
1
2
2
2
3
3
Cleaning the Full Bin Sensors Cleaning the Edge-Sweeping BrushWashing the Bin
Remove and empty the bin.
Use a coin or small screwdriver to remove
the screw holding the Edge-Sweeping
Brush in place.
Release the bin, remove the filter, and
open the bin door.
Wipe the inner sensors with a clean, dry
cloth.
Pull to remove the Edge-Sweeping Brush.
Remove any hair or debris, then reinstall
the brush.
Rinse the bin using warm water.
Wipe the bin door with a clean, dry cloth.
Make sure bin is completely dry. Reinsert
filter and place bin back in the robot.
Closed Door
Important: Do not wash the filter. Remove
the filter before washing the bin.
Open Door
Note: Bin is not dishwasher safe.
To Next Page
Loading...
Need help?
General
