EN
Roomba™ j9+ Owner’s Guide 7
1
1
3
2
2
3
4
4
5
Cleaning the Front Caster Wheel
Cleaning the Multi-Surface Brushes
Pull firmly on the front wheel module to
remove it from the robot.
Remove the brushes from the robot. Remove
the brush caps from the ends of the brushes.
Remove any hair or debris that has collected
beneath the caps. Reinstall the brush caps.
Remove any hair or debris from the square
and hexagonal pegs on the opposite side of
the brushes.
Pinch the brush frame release tab, lift the tab,
and remove any obstructions.
Pull firmly on the wheel to remove it from
its housing (see illustration below).
Remove any debris from inside the wheel
cavity.
Reinstall all parts when finished. Make
sure the wheel clicks back into place.
Remove the bin from the robot and clear
any debris from the vacuum path.
Reinstall the brushes in the robot. Match
the shape of the brush pegs with the
shape of the brush icons in the cleaning
head module
WheelAxle
Important: A front wheel clogged with
hair and debris could result in damage
to your floor. If the wheel is not spinning
freely after you have cleaned it, please
contact Customer Care.
Housing
To Next Page
Loading...
Need help?
General
