EN
Roomba Combo® j9+ Owner’s Guide 9
Cleaning the FilterWashing the Bin Cleaning the Front Caster Wheel
1
2
3
Remove the bin. Remove the filter by
grasping both ends and pulling out.
Remove debris by tapping the filter against
your trash container.
Reinsert filter with ridged grips facing out.
Place bin back in the robot.
Important: The robot will not run if the filter
is not installed correctly. Replace the filter
every two months.
1
3
2
4
Pull firmly on the front wheel module to
remove it from the robot.
Remove any debris from inside the
wheel cavity.
Pull firmly on the wheel to remove it from its
housing (see illustration below).
Reinstall all parts when finished.
Make sure the wheel clicks back into place.
Important: A front wheel clogged with
hair and debris could result in damage to
your floor. If the wheel is not spinning freely
after you have cleaned it, please contact
Customer Care.
Wheel
Axle
Housing
1
2
3
Release the bin, remove the filter, and
open the bin door.
Rinse the dust bin and water tank using
warm water.
Make sure bin is completely dry. Reinsert
filter and place bin back in the robot.
Note: Bin is not dishwasher safe.
Important: Do not wash the filter.
Remove the filter before washing the bin.
To Next Page
Loading...
