10 For more information, visit global.irobot.com
EN
1
3
2
4
Pinch the brush frame release tab, lift the
tab, and remove any obstructions.
Remove any hair or debris from the square
and hexagonal pegs on the opposite side
of the brushes. Replace end caps.
Remove the brushes from the robot.
Remove the end caps from the ends of the
brushes. Remove any hair or debris that has
collected beneath the caps. Reinstall the
brush caps.
Reinstall the brushes in the robot. Match the
shape of the brush pegs with the shape of the
brush icons in the cleaning head module.
Cleaning the Edge-Sweeping Brush Cleaning the Dual Multi-Surface Brushes
1
2
Use a coin or small screwdriver to remove
the screw holding the Edge-Sweeping
Brush in place.
Pull to remove the Edge-Sweeping Brush.
Remove any hair or debris, then reinstall
the brush.
To Next Page
Loading...
