iRobot Roomba i3 User Manual

Roomba
®
i1/i3/i4 Owner’s Guide 9
EN
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
• Changes or modifications not expressly approved by iRobot
Corporation could void the user’s authority to operate the equipment.
• This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference to radio communication will not occur
in a particular installation. If this equipment does cause harmful in-
terference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
• FCC Radiation Exposure Statement: This product complies with
FCC §2.1091(b) for mobile device RF exposure limits, set forth for an
uncontrolled environment and is safe for the intended operation
as described in this manual. Per FCC requirements, maintain a
distance of more than 8 inches (20cm) between any person and the
host device (Roomba robot).
Brazil Radio
For more information, see the ANATEL website www.anatel.gov.br
This equipment is not entitled to protection against harmful
interference and must not cause interference in duly authorized
systems. This product contains the AXF-Y1 board Anatel approval code
12003-20-06178.
Brazil Battery Recycling
Please be sure to dispose the battery properly when necessary. Please
discard it at a recycling center or contact our Support Team for more
information.
Mexico Radio
Contains Module IFETEL ID: RCPIRAX20-1295
For use in Mexico, the operation of this equipment is subject to the
following two conditions:
(1) this equipment or device may not cause harmful interference and
(2) this equipment or device must accept any interference, including
interference that may cause undesired operation.
Argentina Radio
Module Certification: Contains Modula CNC ID: C-25128
Regulatory Information

iRobot Roomba i3 Specifications

General

Dust sensor	Yes
Noise level	- dB
Wet mopping	No
Brush material	Rubber
Dust capacity (total)	- L
HEPA filtration system	-
Shape	Round
Product color	Black, Grey
Battery capacity	- mAh

Weight and Dimensions

Height	95 mm
Diameter	335 mm